Key Features

• Glazing gasket:
  - Same EPM gasket used on exterior/interior and perimeter

• Removable snap-on interior trim cover at head, horizontal and sill allows:
  - Direct head/sill attachment to substrate without using T-anchors
  - Anchor inspection to substrate after glazing
  - Through bolt attachment of panels for ease of installation and for high span wind loads
  - Inspection of critical joinery seals after glazing and repair when necessary

• Screw spline joinery allows:
  - Panelized assembly for “Ladder” type installation

• Injection molded ABS plastic end dams at head, horizontal and sill allows:
  - Tight seals at intersection of vertical/horizontal joints
  - Zone glazed pressure equalized system for water control
  - Water drains to exterior through weep holes located in pressure bar and face cap

• P-Bar:
  - Factory pre-punched alignment holes 9” on center
  - P-bar attached to back members with #12-14 x 1 ¼” HWH self-drilling screws